BI-METAL EasyXcut M3 hole...
Bi-metal M3 Hole Saws with vario-pitched teeth for...
Bi-metal M3 Hole Saws with vario-pitched teeth for applications where fast cutting and low price are the main challenges.
Filtra per
Disponibilità
Diametro attacco
Diametro (D)
Lunghezza taglierina - altezza
Lunghezza totale
Raggio/angolo
Frese
Ci sono 33 prodotti.
Bi-metal M3 Hole Saws with vario-pitched teeth for...
Bi-metal M3 Hole Saws with vario-pitched teeth for applications where fast cutting and low price are the main challenges.
For chamfering thin sheets, plywood, acrylic, etc. For...
For chamfering thin sheets, plywood, acrylic, etc. For interior and exterior contours.
For edging sinks and vanity bowls. The special taper on the...
For edging sinks and vanity bowls. The special taper on the Bearing sleeve allows for perfect guide following around the inside of the bowl.
Rebate cutter with bearing
Rebate cutter with bearing
Bevel cutter with real center cutting edge for direct...
Bevel cutter with real center cutting edge for direct immersion in the material. For foldingand chamfering wood, laminate and plastic sheets.
Bevel cutter with bearing
Bevel cutter with bearing
Cove mould cutter for solid surface
Cove mould cutter for solid surface
Straight bit shank 8mm
Straight bit shank 8mm
Bevel cutter with bearing for solid surface
Bevel cutter with bearing for solid surface
Straight bit shank 12 mm
Straight bit shank 12 mm
Cove mould cutter with bearing
Cove mould cutter with bearing
Diamond PCD rounding over bit Shank 8 mm
Diamond PCD rounding over bit Shank 8 mm
T-Slot cutter with radius
T-Slot cutter with radius
Titman Staff / corner bead HW Z=2 D=28,7 L=23 R=6,3 S=8
Titman Staff / corner bead HW Z=2 D=28,7 L=23 R=6,3 S=8
Titman flute bit HW Z=2 D=32 R=12 L=20 GL=60 S=12
Titman flute bit HW Z=2 D=32 R=12 L=20 GL=60 S=12
Diamond PCD rounding over bit Shank 8 mm
Diamond PCD rounding over bit Shank 8 mm
Profile mould cutter
Profile mould cutter
The following items are required to create the appropriate...
The following items are required to create the appropriate groove:Groover G36552-6.35 and arbor LDTA/8